Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Placing SIM results in original assembly

Thread starter Michel1978
Start date May 1, 2013

Status: Not open for further replies.

May 1, 2013

Michel1978

Mechanical

I know it is possible to place the results of a simulation in the original assembly. But how? I believe it has something to do with STL files.

Michel

I use NX8.5
HP Z600 Intel Xeon E5520 2.27GHz Dual
Quadro FX 3800 5GB
9GB Memory
Windows 7, 64-bit

Groeten, Michel

http://www.kvi.nl

A leading Dutch institute in atomic and subatomic physics