Planes 1,2 & 3

[jbknudsen]

Greetings to all.

I am aware that once a plane has been "autosized" the plane will always be 5% larger than the associated geometry or bounding box.

Here is the question.

Is there a way to have the autosize activated for all new parts or existing parts for that matter? I have highlighted all three, RC and pick autosize. Only the last selected plane is autosized. This is small issue quickly becoming a pain in the back side. I would like the autosize option to be actieve by default.

Thanks to all

Jesus is the WAY the TRUTH and the LIFE,

Jay

 

[SBaugh]

It's not possiblie to pick all 3 and change the autosize to all 3 at the same time. You will need to place an Enhancement request in for this option. Autosize is a new feature to SW03, and with it being a new feature there will be somethings people will not like. The best thing to do is put in an enhancement request.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
When in doubt, always check the help

 

[jbknudsen]

Yup, I should have checked out the beta version prior to posting the thread. Since I am bound to secrecy, I can't tell anyone if the the beta release has automatic autosize planes. I can however tell you that there does not seem to be a need to submit an enhancement request.


Thanks,

Jay