Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plasma keyhole 1

Status
Not open for further replies.
corvin

corvin

Materials
Aug 29, 2002
5
0
0
CA
DOES ANYBODY HAVE ANY EXPERIENCE WITH BEAM ALIGNMENT AND FIT-UP TOLERANCES WHEN PLASMA KEYHOLE WELDING SQUARE GROOVE BUTT JOINTS IN 6 MM (0.25") THICK MATERIAL, WITH NO FILLER WIRE ADDITION? ANY RECOMMENDATIONS ON EQUIPMENT SELECTION?
 
Status
Not open for further replies.

Similar threads

bobosk
  • Locked
  • Question
Wlding plasma PAW
Replies
0
Views
1
bobosk
bobosk
trainguy
  • Locked
  • Question
Plasma Arc Welding - not in North America?
Replies
4
Views
5
meltedEng
meltedEng
VoyageofDiscovery
  • Locked
  • Question
Plasma cutting of steel plate in preparation for welded fabrication of multi-sided steel monopoles 4
Replies
7
Views
8
VoyageofDiscovery
VoyageofDiscovery
Gregorydas
  • Locked
  • Question
How to find Plasma Cutting Gas Flow Rate?
Replies
5
Views
6
chicopee
chicopee
gmwylie
  • Locked
  • Question
plasma nitriding
Replies
1
Views
2
dhengr
dhengr
Back
Top