Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plastic Dimensional Standards

Thread starter SDETERS
Start date Mar 3, 2016

Status: Not open for further replies.

Mar 3, 2016

SDETERS

Agricultural

Is there are an industry standard similar to the NADCA for aluminum die castings, for plastic injection molded parts?

We are looking for some standard tooling mismatch numbers for some plastic parts we are working on.

I found a Society of the Plastics Industry document from 1998.