Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plastic Hinges for Pushover Analysis by API code?

Thread starter G2010
Start date Jul 20, 2010

Status: Not open for further replies.

Jul 20, 2010

G2010

Structural

Hi Everyone,

I am trying to write some procedure with API in SAP2000 to create a simple frame model and add the plastic hinges to the frames. I have been looking around the API documentation, but I have not found any internal procedure to add the hinges to frame by code.

Have Anyone else had the same situation?

Thanks