Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plastics and Polyurethan Foam

Status
Not open for further replies.
seniorprojectmanager

seniorprojectmanager

Mechanical
Jan 25, 2008
8
Some years ago, SPI, the Society of Plastics Industry,Inc, New York had issued a technical bulletin (cost a few dollars). Does anyone know if the Bulletin U118-R still valid, or if it has been renamed or withdrawn?
 
Status
Not open for further replies.

Similar threads

Ahmed Mohamed
  • Question
Fitting connected to an old premix foam tank
Replies
7
Views
3K
LittleInch
LittleInch
bks2000
  • Question
Jacketed Gaskets and ASME B16.20
Replies
1
Views
706
akpipelineengr
akpipelineengr
Eric Kelly
  • Locked
  • Question
Reduced-Noise Gas Flow Design Guide and spreadsheet by Nelson and NASA 1
Replies
9
Views
230
Prometheus21
Prometheus21
GD2
  • Question
Flexibility and Seismic analysis - Piping system 2
Replies
8
Views
696
RVAmeche
RVAmeche
AnisaMaski
  • Locked
  • Question
Axial, bending and Torsional Stiffess
Replies
1
Views
134
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top Bottom