Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plate with Center Hole, crack on hole

Status
Not open for further replies.
amithd92

amithd92

Mechanical
Apr 10, 2014
4
I need help in drawing and stimulating "Plate with Center Hole, crack on hole".
Then stimulate it and get Stress and displacement constraints to find K1(stress intensity factor)

Assume any values for crack length and plate length and all... Plate is under plane strain condition.

Image is attached.

Please help me its kind of urgent :) Thanks a lot.
 
 http://files.engineering.com/getfile.aspx?folder=360817f9-e532-490b-8e20-07d3fba64665&file=Capture.JPG
Status
Not open for further replies.

Similar threads

H
  • Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
2K
karachun
karachun
IJR
  • Locked
  • Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
509
IJR
IJR
bezutew
  • Locked
  • Question
Closed crack
Replies
1
Views
76
SPDL310
SPDL310
bkal
  • Locked
  • Question
Mode Selection Based on the Mode Coefficients
Replies
0
Views
116
bkal
bkal
shiraz883
  • Locked
  • Question
Stresses increase on adding thermal boundary conditions/ thermal load
Replies
1
Views
153
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top Bottom