rajubhai26
Student
- Dec 8, 2024
- 8
Hello everyone,
I would like to ask for guidance on how to program PLC ladder diagram on CX-programmer for OMRON CP1E-N60 to control XZ linear stage motion. I have searched the internet but didn't not received a proper understanding on this type of programming. I would like know whether HMI or Pulse Output used here. Also want to know whether it is necessary to use python programming
The XZ motion stage uses stepper motor for motion control. Not sure whether to use stepper drive to intercom with PLC.
I am sharing another discussion thread on my project WLAM. Please do share your point of view on these.
Here is my full project WLAM which I going to integrate:
www.eng-tips.com
I would like to ask for guidance on how to program PLC ladder diagram on CX-programmer for OMRON CP1E-N60 to control XZ linear stage motion. I have searched the internet but didn't not received a proper understanding on this type of programming. I would like know whether HMI or Pulse Output used here. Also want to know whether it is necessary to use python programming
The XZ motion stage uses stepper motor for motion control. Not sure whether to use stepper drive to intercom with PLC.
I am sharing another discussion thread on my project WLAM. Please do share your point of view on these.
Here is my full project WLAM which I going to integrate:
Wire Laser Additive Manufacturing - Student Engineer General Discussion
HP20Y LASER WELDING HEAD (2000W) Furukawa Single-mode Fiber laser (FES500S-7) 500W Wire feeding system Chiller water Shielding gas Platform/stage control PLC control system Questions: 1. May I know whether the single wobble welding head used for wire laser melting? Is necessary? 2. Based on...
www.eng-tips.com
