Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plotting stress in layer of laminate using Abaqus CAE

Status
Not open for further replies.
Zeck

Zeck

Mechanical
Jan 2, 2014
38
0
0
DE
Hello,

could anyone advice me how to show stress in different layer for example in layer 3 instead of layer 1 of laminate modelled like shell?
Thanks for help.


0B6iSciGpwMfvTHVDVjVyS1hqX2c
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Result > Section Points

Maybe you have to add more section points into your field output request. By default you only get the outer region.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Marekcom
  • Locked
  • Question
Structural acoustic coupling using Abaqus
Replies
2
Views
15
Marekcom
Marekcom
abc123ali
  • Locked
  • Question
error opening abaqus cae
Replies
2
Views
24
abc123ali
abc123ali
mj345
  • Question
Hybrid Meshing in ABAQUS
Replies
1
Views
42
FEA way
FEA way
MPa94
  • Locked
  • Question
Fully coupled thermal-stress analysis in Abaqus/Standard- equations
Replies
8
Views
34
FEA way
FEA way
mikylangel
  • Locked
  • Question
How can I fix this ABAQUS CAE error? “96 nodes are missing degrees of freedom. MPC/equation/kinemati
Replies
5
Views
37
FEA way
FEA way
Back
Top