Point Style in SW

[brownnote]

Is there a way to change how points are displayed on a drawing? I have shown a 3D sketch that is just points. The points are representations of holes on the part. When I plot out the drawing the points get absorbed by my centerlines.

I now need to change the way that the points are displayed. In AutoCad you could tell the software if you wanted to have a cross or an X for points. I have yet to find anything in SW.

Does anyone have a Macro that would lay an X or a cross onto existing points in a drawing.

Your help is appriciated.

 

[APPENG]

To the best of my knowledge there is no way to change the display type of a point. The only types of points you can change are the virtual sharps.



Regards,
Jon
jgbena@yahoo.com