freerangequark
Mechanical
- May 11, 2005
- 88
I have an ellipse sketch.
I placed a point 1" from the end of the curve. This is the pattern leader.
I need 20 points evenly spaced ON the ellipse starting from the pattern leader.
When I pattern the point using the "CURVE" pattern option, the points are laterally offset from the curve by 1". I need them on the curve.
What am I doing wrong? (file attached)
Thanks,
Glenn
I placed a point 1" from the end of the curve. This is the pattern leader.
I need 20 points evenly spaced ON the ellipse starting from the pattern leader.
When I pattern the point using the "CURVE" pattern option, the points are laterally offset from the curve by 1". I need them on the curve.
What am I doing wrong? (file attached)
Thanks,
Glenn