Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Poist for Smartcam

Thread starter 2machineit
Start date Sep 16, 2002

Status: Not open for further replies.

Sep 16, 2002

2machineit

Industrial

I am not good on making a new post processor. Does anyone have a good post for a Hitachi Seiki HiCell 40ll and a Hitachi Seiki VK machining center. We just received these machines from another division and they used Nicam to program. I really don't like to use Nicam.