polar drilling

[sasha1]

Hi
Im using NX6 my problem is that I need to output drilling paths as POLAR moves, is there any way of doing that from within NX
Many thanks

 

[JohnVincent]

You have to program your drilling operations as normal and under Objects=> Start Events select the Set Polar UDE and set to on. You may have to make changes in your post depending on you machine/controller.

 

[sasha1]

Thanks John
Ive tried using the poalr UDE prior to my post but unfortunatly the post doesnt handle it. I was hoping for an alternative but will have to get onto our postbuilder (externally sourced)