Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Post Processing...Is there a way to pull stress intensity factors?

Status
Not open for further replies.
2bit

2bit

Aerospace
Feb 26, 2010
1
I have a FEM that I have pulled stresses and pin loads from. I was wondering if there is a way to pull stress intensity factors at a radius. I am using NX6.
 
Status
Not open for further replies.

Similar threads

NXsupport
  • Question
Is there a quick way to dynamically move a datum place across a body to measure minimum wall thickness
Replies
1
Views
827
Toost
Toost
NXsupport
  • Question
Is there a way to make extrude dialog remember the limits options set in the dialogbox
Replies
3
Views
2K
Ammaniya
A
Werner K
  • Locked
  • Question
Pull expression values into a component when adding to an assembly
Replies
5
Views
308
Werner K
Werner K
BCE75
  • Question
Does NX have a way to display layout guides in addition to the grid on a drawing sheet?
Replies
2
Views
1K
BCE75
BCE75
AlexCLE
  • Question
Post builder change full circles to shorter arcs
Replies
0
Views
825
AlexCLE
AlexCLE

Part and Inventory Search

Sponsor

Back
Top Bottom