Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

post processor set-up

Thread starter moog2
Start date Apr 7, 2009

Status: Not open for further replies.

Apr 7, 2009

moog2

Mechanical

I'm modifying some posts (for NX6), I have some custom commands which work well in the fanuc post for the "daewoo", but when i put them into the Deckel maho "DMU 60T", which is for a heidenhain it won't output the text.
I'm want to have the tool number, tool dia etc listed at the start of prog.
Is there something i need to turn on in the post builder to get it to work, thanks