hi.
Is it possible to inquiry nc program group attributes via TCL?
or any other solution to the next problem:
i would like some general information into the shopdoc table, for example: roughing, or drilling 4 pieces of 6H7 holes etc. Bcos a program group contains more operations, it looks practical attaching comments to the program group..
Any help would be appreciated!
----
kukelyk
Is it possible to inquiry nc program group attributes via TCL?
or any other solution to the next problem:
i would like some general information into the shopdoc table, for example: roughing, or drilling 4 pieces of 6H7 holes etc. Bcos a program group contains more operations, it looks practical attaching comments to the program group..
Any help would be appreciated!
----
kukelyk
