Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Power drawbar retention force specifications.

Status
Not open for further replies.
bigj2

bigj2

Industrial
May 22, 2003
17
I would like to know what the retention force is for automatic drawbars on machine spindles by taper #50, 45, 40, 30, NMTB and HSK 50, 63 and 80. I have a pull force gauge and was told it is out of spec and needs to be calibrated. How much can the actual force vary from the spec. + or - lbs. of force?
 
Status
Not open for further replies.

Similar threads

yoshiKoshi
  • Locked
  • Question
Calculating linear/thrust force from a linear ball screw and motor combinaton
Replies
2
Views
585
yoshiKoshi
yoshiKoshi
ZepBal
  • Locked
  • Question
Force Needed
Replies
7
Views
99
tmschrader
tmschrader
Jack_the_JOAT
  • Locked
  • Question
Designing a quadcopter powertrain.
Replies
1
Views
491
btrueblood
btrueblood
cn5
  • Locked
  • Question
ERMAKSAN POWER BEND FALCON
Replies
2
Views
85
berkshire
berkshire
jmdlok
  • Locked
  • Question
Single Point Diamond Turning Cutting Force Analysis
Replies
0
Views
74
jmdlok
jmdlok

Part and Inventory Search

Sponsor

Back
Top Bottom