rocksolid
Industrial
- Nov 1, 2001
- 17
I was wondering if anybody knew of a good way to design a powered roller conveyor with rollers being quite small and close together. My roller diameter is 3/4". My center spacing is 1" roller to roller. I have to achieve a roller surface speed of approx. 215 FPM. My roller face length is 36" wide. I have tried some different ways, but am unhappy with all results so far. I have means of powering this via
AC OR DC Motor. I can even use air. If need be I may be able to power everyother roller, but would really like to power every one. Any suggestions would be much appreciated.
Thanks,
Rocky
AC OR DC Motor. I can even use air. If need be I may be able to power everyother roller, but would really like to power every one. Any suggestions would be much appreciated.
Thanks,
Rocky