Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Pressure contact on shaft/hub coupling
- Thread starter dimi81
- Start date
dimi81
Since you are concerned about the contact pressure at the joint, the hub must not be sliding along the hex. The coupling is more than likely at the end of the shaft so why not make it easy for yourself and turn the hex to the diameter across flats and add a key? Now everything is "text book".
Since you are concerned about the contact pressure at the joint, the hub must not be sliding along the hex. The coupling is more than likely at the end of the shaft so why not make it easy for yourself and turn the hex to the diameter across flats and add a key? Now everything is "text book".
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Helpful tip
- Locked
- Question