Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pretension spindle bearing

Thread starter Spox88
Start date Dec 22, 2015

Status: Not open for further replies.

Dec 22, 2015

Spox88

New member

Hello friends,
am carrying out a simulation in Abaqus/Explicit,whereby i have to pretension two spindle bearings of the type HCB7014 mounted in O-Arrangement in axial direction(see photo).Unfortunately am not sure of the procedure for successfully implementing this in Abaqus.I will be immensely grateful for any help/suggestions pertaining to this.

Thank you.
Spox

http://files.engineering.com/getfile.aspx?folder=3d3f8bf9-9192-41a6-b2e4-ab273c66334a&file=Spindle_Bearing.JPG