Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

previewCFG.sldprt

Status
Not open for further replies.
DanielRo

DanielRo

Nuclear
Feb 22, 2008
32
Performing an upgrade from SW2010 to SW2011 and am occasionally receiving an error message on this file - previewCfg.sldprt. It's a Toolbox-Drop File Error; has invalid dimensions. Can anyone elaborate on this? See attached bmp.

Thanks,
Dan
 
Replies continue below

Recommended for you

Sort by date Sort by votes
One, you shouldn't upgrade from one major release to another, you should do a clean install.
Two, when you did upgrade, did you upgrade your toolbox installation as well?
Three, see one.

Jeff Mirisola, CSWP
Director of Engineering
M9 Defense
My Blog
 
Upvote 0 Downvote
What is your reasoning behind not upgrading? The toolbox is being upgraded at the same time that the vault is.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom