Print Screening

[rnjroles]

For some unknown reason when I plot a map form my computer with the appropriate linetypes I get a incorrectly screened map, whereas if I use an associates computer to plot the same map (with the same settings as near as I can tell) the map comes out right. Does anyone know of a setting that could cause this?

Thanks

 

[borgunit]

Check your associates DIMSTYLE setting when plotting.

"Everybody is ignorant, only on different subjects." — Will Rogers

 

[rnjroles]

Thanks for the response.

I should have mentioned that I am using Land Desktop 2005. I don't see a DIMSTYLE setting - where can I find it?

DIMSTYLE sounds like it may pretain to dimensions - what does it do?

 

[borgunit]

My mistake. I meant PLOTSTYLE. If it is like AutoCAD, you expand the plot dialog with an arrow at the lower right.

"Everybody is ignorant, only on different subjects." — Will Rogers

 

[rnjroles]

Turns out I was using an old driver. The IT guy got it squared away for me.

Thanks for the efforts.