Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/E 2001 - Pro/Mechanica (Polypropylene)

Thread starter ella0509
Start date Apr 1, 2005

Status: Not open for further replies.

Apr 1, 2005

ella0509

Mechanical

Hello,

I'm quite new to Pro/Mechanica and have been asked to do some analysis with PolyPropylene componentry (Pressure Vessel). Is this possible with Pro/Mechanica?? I know it is with steel components, but I'm thinking about the non-linear material aspects of the PolyProp and how Pro/Mechanica deals with it.......

Thanks,
Lee