Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/E surface Merge

Thread starter proEdj
Start date Dec 6, 2004

Status: Not open for further replies.

Dec 6, 2004

proEdj

Mechanical

I am attempting to create a surface model to use for a hydrodynamic analysis. I have a complex assembly that I planned on performing a shrinkwrap, then merging the surfaces. Pro/E is having a difficult time defining the geometry between many of my complex surfaces. Is there an easier way to create the model I am looking for. Keep in mind that I want all negetive geometry (i.e. holes) on the exterior surface of my assembly to be ingnored.

Thanks,

proEdj