Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro E to Ansys Config.Pro File Needed

Thread starter manker
Start date Sep 18, 2003

Status: Not open for further replies.

Sep 18, 2003

manker

Automotive

Hi, I am hoping that someone can help me out. I have Pro Mechanica and Structural Ansys and i am trying to mesh parts in Pro E and use the Ansys solver to solve on line , I keep getting an error that says can't find ansys solver check installation. i am able to output the ans file to ansys and run the file but i am not able to solve in Pro Mechanica with the Ansys solver is there a special config.pro file that i need . Thanks in Advance. Mike