Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/E Wildfire Flexibility

Thread starter fitch42044
Start date Mar 1, 2004

Status: Not open for further replies.

Mar 1, 2004

fitch42044

Mechanical

Does anyone know how to use the Make Flexible feature in Wildfire? I am trying to make a thin tube flexible enough so that one end is stationary and the other is able to slide back and forth with a sliding table. Is this possible? If so, what's the easiest way to do it?

Thanks