Pro/Mechanica to Nastran

[emp519]

Is there a way I can export a meshed model created in Pro/Mechanica 2001 into MSC.Nastran version 2000 ? Thanks in advance.

 

[mloew]

emp519,

Pro/MECHANICA FEM mode will allow for export in ANSYS, NASTRAN, and COSMOS formats.

Best regards,

Matthew Ian Loew
"Organizations cannot make a genius out of an incompetent. On the other hand, disorganization can scarcely fail to result in efficiency." -- Dwight D. Eisenhower

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.

 

[emp519]

Thanks mloew, could you please tell me how do I go about it. Or, which file should I export from Pro/Mechanica into say Cosmosworks.

 

[mloew]

emp519,

You are now asking a specific question to Pro/MECHANICA. I suggest you look at the faq Before you ask for help
(faq828-849) in the PTC: Pro/MECHANICA Forum (forum828). If you still have have questions, please make a detailed post in the appropriate forum.

Good luck.



Best regards,

Matthew Ian Loew
"Organizations cannot make a genius out of an incompetent. On the other hand, disorganization can scarcely fail to result in efficiency." -- Dwight D. Eisenhower

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.