Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PRO-PROCESS MENU

Status
Not open for further replies.

SteveVan

Mechanical
Dec 10, 2002
16
0
0
US
I'm using WildFire 2.0
I'm using Pro-process creating a parts manual. Every once in a while the menu manager will dispear. The only way i found to get it back is to close pro-e and re-open the assemblies. Is there an easier way.
 
Replies continue below

Recommended for you

Status
Not open for further replies.
Back
Top