Hey...
Can anybody give some help with creating a weld..?
I want to show a weld between a piece of honed tube and a clevis.
Both are prepared, 45 degree chamfer on each and I want to show a groove weld, if that is the correct weld type to use.
PTC have excelled themselves again with their attempt at providing help files...their description does not match what's shown on the screen.
I am going nowhere and I need some pointers...
Thanks in advance
Adrian
Can anybody give some help with creating a weld..?
I want to show a weld between a piece of honed tube and a clevis.
Both are prepared, 45 degree chamfer on each and I want to show a groove weld, if that is the correct weld type to use.
PTC have excelled themselves again with their attempt at providing help files...their description does not match what's shown on the screen.
I am going nowhere and I need some pointers...
Thanks in advance
Adrian