Pro_e Settings

[jedayfalco]

Hi all

I am new to Pro_e environment and trying to go on over the tutorials such as getting started.pdf in which i am asked to create a phone lens with an extrusion depth of 0.02 inch.But my proe pops up an error information saying that..." Wrong value 0.0200. Range is 0.0600 to 1000000.0000" on the screen when i give required depth of extrusion.

Can anyone help me to change this settings of proe?

thanks in advance

 

[looslib]

switch your accuracy type
Edit-Setup-Accuracy

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli