Probing Cut Sections? 1

[JamboTron]

Has anyone else encountered problems whilst probing a cut section on a stress/displacement plot using SW/CW 2006? Sometimes it'll work fine, but ocasionally it wont, I've played aroung with the obvious filters(face,edge,point)but still nothing. Is there possibly another filter I'm not aware off?

 

[jdesouza]

Try a "forced rebuild" (control+Q). That may help. I've had the same problem and this helped....

~Jeff~

SolidWorks 2006 SP3.1 on WinXP SP2
Pentium(R)4 CPU 3.60GHz 1.00GB of RAM

 

[JamboTron]

OK, I'll give it a go.

Thanks.