Problem with assembly when i replace component when have the same name

[RSilva]

Hello

Every time i receive 1 Step, i create a new folder and i open that assembly there and i add the date at the end of the name of that folder.
I receive Steps with few updates of 1 assembly but when i try to replace that assembly with "replace component", nx update all unless the components that have the same name.
The way that i use now is save before replace component, close that area, open the assembly that i received and after that open my area and only after replace, but i want to know if there are any way to replace without have to close the area that i'm working and have all assembly updated?

 

[gelsonnicoletto]

Hello,

Try to change the "Assembly load options" with Allow Replacement ON.

Gelson Z. Nicoletto
Eng. Supervisor
Mould Desing
Brazil