enginerd1959
Industrial
I've been running 2 monitors for over a year now and have had few problems. A couple months I upgraded to a new system with a Quadro FX 1400 card.
Every now and then when I click "Maximize" the SolidWorks window decides to go to the right monitor, but displays double-wide (half the window is even further to the right, off screen (as though I have a third monitor!).
None of the other programs do this and SolidWorks only does it occasionally. I can't figure out how to consistantly recreate this problem. I've made sure there are no special settigs for SolidWorks windows in nVidia's settings.
Windows 2000
SolidWork 2005 SP4.0
nVidia Quadro FX 1400
Driver version 71.84
Every now and then when I click "Maximize" the SolidWorks window decides to go to the right monitor, but displays double-wide (half the window is even further to the right, off screen (as though I have a third monitor!).
None of the other programs do this and SolidWorks only does it occasionally. I can't figure out how to consistantly recreate this problem. I've made sure there are no special settigs for SolidWorks windows in nVidia's settings.
Windows 2000
SolidWork 2005 SP4.0
nVidia Quadro FX 1400
Driver version 71.84
