Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problems w/SWX 2005, Quadro card & Dual Monitors

Status
Not open for further replies.
enginerd1959

enginerd1959

Industrial
Oct 1, 2002
65
I've been running 2 monitors for over a year now and have had few problems. A couple months I upgraded to a new system with a Quadro FX 1400 card.

Every now and then when I click "Maximize" the SolidWorks window decides to go to the right monitor, but displays double-wide (half the window is even further to the right, off screen (as though I have a third monitor!).

None of the other programs do this and SolidWorks only does it occasionally. I can't figure out how to consistantly recreate this problem. I've made sure there are no special settigs for SolidWorks windows in nVidia's settings.

Windows 2000
SolidWork 2005 SP4.0
nVidia Quadro FX 1400
Driver version 71.84
 
Status
Not open for further replies.

Similar threads

jassco
  • Locked
  • Question
Unable to use dual dimension in feature control frames (GD&T) in Solidworks 2023
Replies
5
Views
1K
3DDave
3DDave
Rodger Furey
  • Locked
  • Question
Solidworks Configurations - file size & non-dimensional differences
Replies
2
Views
440
SSCon
SSCon
powerhound
  • Locked
  • Question
Dual dimensioning and dimension format
Replies
8
Views
1K
ctopher
ctopher
Platypusimon
  • Locked
  • Question
calculating the mass & volume of section of a part/assembly model in solidworks
Replies
10
Views
960
jassco
jassco
borsht
  • Locked
  • Question
Tolerancing grayed out on drawing when adding & modifying hole dimensions
Replies
1
Views
777
SBaugh
SBaugh

Part and Inventory Search

Sponsor

Back
Top Bottom