Anyone aware of an industry spec that defines a mold in place seal similar to a Parker gask-o-seal? I have an application where O-rings are an installation risk and would like a seal molded into Alum parts. Program requirements do not allow calling out supplier trade name materials and processes so if there is an SAE, MIL or other such spec that would solve the problem.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Process spec for mold in place seals
- Thread starter cjccmc
- Start date
Similar threads
- Locked
- Question
- Locked
- Question