ProE and Sigmetrix

[aogburn1]

I am using Pro-E for designs and drawings and my company is considering GD&T Advisor by Sigmetrix.
Does anyone have experiemce with this program, good or bad?

What can we expect GD&T Advisor to do for us that Pro-E does not already?

Ivan

 

[looslib]

Usng the Sigmetrix modules will give you a report on how the tolerances on individual parts could interfere or become too large of a gap at the assembly level. It basically takes the parts and runs them through their tolerance limits in conjunction with your other components.
It does take some training to understand the system and consistent use to hone your skills. The analysis set up in Sigmetrix also takes some time, but may be better now, since I haven't used it since WF1 in 2005.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli