ProE double dimension in drawing

[sticker]

How do you add a parametric dimension note &dxxx to a table without the system automatically removing the paramtric dimension shown in the view with the same dimension?
For example I want to show the same dimension in the field of the part view as well as in a note.

 

[looslib]

Simple, you can't! The software considers that dual dimensioning.
The best you can do is create a parameter pointing to the original dimension internal parameter, then use your parameter in the table.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli

 

[sticker]

Thanks, We considered the separate parameter too but didnt want a work around and hoped for a config or .dtl setting allowing over constrained double dimensioning instead.

 

[dgallup]

You can always create a double dimension in the drawing. I would make it a reference dimension.

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.