PROFILE TOLERANCE OF SPLINES - CLASS 4

[wallyd999]

I'm looking thru the ANSI B92.1 spline book (table #3) and trying to find out if the profile tolerance needs to be compensated as the tooth thickness or space width. I believe that the book reads that the multiplication factor only applies to the CTT or CSW. Can anybody confirm this? I also need the Para number and page if possible.

Thanks to all.

 

[wallyd999]

wallyd999 (Aerospace) 14 Mar 08 14:01
I'm looking thru the ANSI B92.1 spline book (table #3) and trying to find out if the profile tolerance needs to be compensated as the tooth thickness or space width. I believe that the book reads that the multiplication factor only applies to the CTT or CSW. Can anybody confirm this? I also need the Para number and page if possible.

Thanks to all.

 

[KENAT]

forum1103 if you dont get the answer you need here. Please link this post there.

KENAT, probably the least qualified checker you'll ever meet...

 

[wallyd999]

Thanks.

This post was a repeat which you are the 1st to respond.