Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PROGGRESSIVE DIE STRIP LAYOUT PROBLEM

Thread starter metalquest
Start date Aug 30, 2011

Status: Not open for further replies.

Aug 30, 2011

metalquest

Mechanical

I have been using NX for about 4 years, when I use the proggressive die strip layout button an incorrect box appears and I was wondering if anyone could tell me what I need to do to get the correct box to appear so I can use this option. I am using NX 7.5. I seen this before when I was in the training class, but that was over 3 years ago.