Oct 26, 2005 #1 boffin5 Aerospace Dec 31, 2003 96 I know this is simple, but I can't figure out how to project a point onto a line, a normal projection, in order to create a new point. Help!
I know this is simple, but I can't figure out how to project a point onto a line, a normal projection, in order to create a new point. Help!
Oct 26, 2005 #2 3dlogix Mechanical Jan 31, 2002 435 Use Create Point > On Curve and select either Length Ratio or Actual Length. This is the best way. Steve http://www.sprdesign.comhttp://www.3dlogix.com Upvote 0 Downvote
Use Create Point > On Curve and select either Length Ratio or Actual Length. This is the best way. Steve http://www.sprdesign.comhttp://www.3dlogix.com
Oct 26, 2005 #3 foxbr New member Oct 18, 2005 17 If you want to actually "project" a point on to a curve. Project another cuvre across the other curve and make point at the intersection of the 2 curves. Upvote 0 Downvote
If you want to actually "project" a point on to a curve. Project another cuvre across the other curve and make point at the intersection of the 2 curves.
