Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Protrusions on curved/lofted surfaces?

Status
Not open for further replies.

Pulsar123

Mechanical
Feb 8, 2021
13
Dear all, I was wondering how this could be done. I want to create cones on the surface of a sphere or arbitrary curved surfaces in Solid Edge, but I'm not sure how I could do this. Couldn't find anything relevant on YouTube. I tried the trim and extrude functions and all manner of sketches, but can't seem able to do it. I should point out that I want the cones to be arranged at equal distances from each other on this curved surface, rather than just randomly extruding. Help would be greatly appreciated. Thank you.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor