Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pulse firing gas valve

Thread starter op9
Start date Mar 8, 2014

Status: Not open for further replies.

Mar 8, 2014

op9

Industrial

I am interested in sourcing a manufacturer of gas valves that can be used for an on/off pulse burner system for a brick kiln. I am aware that Kromschroder have the VAS series valves ideally suited for this application....up to 6 pulses/min. However they are only rated to 50kPa. I need a valve rated to at least 100kPa and hopefully higher. The valve has to be specifically suited for this duty. (eg the Kromschroder valves are tested to greater than 3,000,000 cycles).
Thanks in advance.
Rod.

Rod Nissen.
Combustion & Engineering Diagnostics