Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Danlap on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PUSHOVER ANALYSIS by STATC GENERAL (URGENT)

Status
Not open for further replies.

daniel8892

Civil/Environmental
Sep 15, 2012
7
Hi, I am currently running a pushover analysis using static general with displacement of 65mm and various axial load as my project is about the effect of axial load in the column by performing pushover analysis. I have tried so many times since past 6 weeks and searched for solution including this forum. Yet I am still not able to solve as I am new to ABAQUS and do not really understand. I know the issue is happen on the time increment as I keep on getting the same error such as too many attempt made for this increment and etc. Is it possible to tell me what I should do ?

Thank you and appreciate
 
Replies continue below

Recommended for you

If you post the error you are getting, someone here can help you out.
 
"my project" ... work or school ?

either way, is there no-one there who can help ?

have you read the manual ? run the example problems ? asked the help desk ?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor