windell
Mechanical
- Jun 16, 2005
- 26
Hi, I'm building a 1/2 wavelength UHF dipole for approxmately 434MHz and I'm currently searching for a high quality balun with low loss. The balun need not be wideband since transmission will occur only at 434MHz. The output from the radio will be at most 1W. 50ohm unbalanced to 100ohm balanced is what is required.
I did some searching online, but only found high power baluns and I looked on digikey and mouser, but they seem to have baluns with a fair amount of loss.
What I am looking for is a low power balun that has low loss and is small enough to mount on a printed circuit board. Does anyone have any suggestions?
Much appreciation,
Windell
I did some searching online, but only found high power baluns and I looked on digikey and mouser, but they seem to have baluns with a fair amount of loss.
What I am looking for is a low power balun that has low loss and is small enough to mount on a printed circuit board. Does anyone have any suggestions?
Much appreciation,
Windell