Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Quanitifying M&E in an office block strip out

Status
Not open for further replies.
xtract

xtract

Mechanical
Feb 5, 2011
22
GB
Hi,

Can anyone advice where I may source the information to help calculate the volume of M&E material in a typical office block strip out?
 
Status
Not open for further replies.

Similar threads

Rodger Furey
  • Locked
  • Question
Engineering Office Layout. 11
2
Replies
34
Views
170
mfgenggear
mfgenggear
Radius1
  • Locked
  • Question
Run out calculation
Replies
7
Views
58
mfgenggear
mfgenggear
Mizzy07
  • Question
Redesigning an elevation mechanism, does this make sense? 2
Replies
8
Views
79
BEMPE16524
BEMPE16524
renasis
  • Question
ASME B18.3 & ASME B18.2.8 clearance hole fits
Replies
2
Views
77
drawoh
drawoh
evelynstpl
  • Question
Whether insulation (Hot, Cold, Personnel) is applicable for FRP Tank & Tower
Replies
8
Views
91
georgeverghese
georgeverghese

Part and Inventory Search

Sponsor

Back
Top