Query for heat exchanger using PV elite software

[sarawana]

Dear frds,

Kindly clarify I prepared BJM type of exchanger, then I run the output file but I get output only for shell, channel, flange, nozzle & saddle for internal & external pressure accordingly.
I can’t get TUBE SHEET, BAFFLE PLATE & PARTITION PLATE calculation output for pv elite. How can I get tube sheet & baffle plate calculation output for pv elite


Regards,
saravana.

 

[SnTMan]

saravanan.E., you have posted this same question in the B&PV forum. This is known as "double posting" and is discouraged. Pretty much the same people inhabit that forum and this one, so it is not necessary to post in both.

Please delete this post or the other. TIA

The problem with sloppy work is that the supply FAR EXCEEDS the demand

 

[sarawana]

SnTMan., I accept your point i will remove a post on B&PV forum. and kindly clarify about my query.

 

[SnTMan]

saravanan.E, I'm afraid I can't help much with your query. Sorry. My experience with PVE is very limited. I know it should be running your tubesheet. I felt the process to do so was kind of clunky.

I am not sure the other calcs mentioned are native to PVE. I'd suggest you contact Support.

Thanks for deleting the other post, and good luck.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand