Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Question about Sensitivity Block in ASPEN Plus

Thread starter jari001
Start date Aug 9, 2013

Status: Not open for further replies.

Aug 9, 2013

jari001

Chemical

Hi everyone,

I'm trying to use the sensitivity block in ASPEN Plus Ver 7.3 and it seems to me that you are not able to vary the mole fraction of a component in the feed stream to test the response on a product on said changes in mole fraction. I would appreciate it if someone could tell me if there is a way to do this.

Thanks in advance,
J