"DISPSILH" in 2006

[ccable]

In AutoCAD 2000 DISPSILH=1 used to remove the display lines on a cylinder. This does not seem to be the case in 2006, the lines are remove when plotting but not in display any ideas. Thank You

 

[borgunit]

Could this glitch be the reason? ...

http://discussion.autodesk.com/thread.jspa?threadID=488621

"Everybody is ignorant, only on different subjects." — Will Rogers

 

[ccable]

Thanks Borgunit, not too bothered about plotting I just want the display to be smooth and without facets, clients often sit over me whilst I'm modelling and it spoils the effect!!

 

[CarlB]

Is the cylinder a solid rather than a surface?

Did you also use the "hide" command?