Hi Guys,
I have just started using Wildfire 4.0. It was Wildfire 2.0 before this.
The problem I am having is with the measure function, as in " Analysis / measure ". I want to measure the distnce between two parallel surfaces on seperate parts. I find it very difficult to pick up a surface in a complex assembly. In 2.0 it was possible to choose surface beforehand, but this is not possible in 4.0.
Any tips on how to overcome this?
I have just started using Wildfire 4.0. It was Wildfire 2.0 before this.
The problem I am having is with the measure function, as in " Analysis / measure ". I want to measure the distnce between two parallel surfaces on seperate parts. I find it very difficult to pick up a surface in a complex assembly. In 2.0 it was possible to choose surface beforehand, but this is not possible in 4.0.
Any tips on how to overcome this?