belorado
Mechanical
- Jun 10, 2014
- 1
Hello everybody,
When using "tie constraint" between two parts which are not stuck (there is a 5 mm gap between both), I specify a "position tolerance" of 6 mm. No problem with that, my calculation works fine.
My question is : Is it possible to check visually which node is connected to which one, once the mesh is done ? It could be useful to check if my "position tolerance" value is relevant or not.
Thank you in advance for your help,
Best regards,
Belorado.
When using "tie constraint" between two parts which are not stuck (there is a 5 mm gap between both), I specify a "position tolerance" of 6 mm. No problem with that, my calculation works fine.
My question is : Is it possible to check visually which node is connected to which one, once the mesh is done ? It could be useful to check if my "position tolerance" value is relevant or not.
Thank you in advance for your help,
Best regards,
Belorado.